FDI is committed to providing the best support possible for it's products.  If there is an answer that you cannot find or if you have additional questions, you can send an email to .  We will respond directly to your inquiry as quickly as possible.

1. The USB-MPC does not work correctly.  Why?
2. Do you have Linux drivers available for the USB-MPC?
3. Do you have National Instruments LabView drivers for the USB-MPC?
4. Do you have a development kit for using the USB-MPC in our application?
5. Do you have example programs for using the USB-MPC?
6. What speeds can the MDIO run?
7. Does the USB-MPC support MDIO Clause 45?
8. My I2C does not want to talk to my device at address A0h. Why is that?
9. What speed does the I2C bus run?
10. My USB-MPC seems to take a very long time talking I2C with the target and eventually fails with a read error. What’s going on?
11. My target is dead and does not power up when plugged into the USB-MPC. What could be wrong?
12. My target has power, but communications is failing?
13. Can I setup the USB-MPC to send more than 2 bytes?
14. Can I connect my USB-MPC through a hub?
15. My USB-MPC is hanging when I do MDIO Clause 45 accesses, but doesn't fail when I do MDIO Clause 22.
16. When doing MDIO Clause 45 instructions, a MDIO Clause 22 instruction appears in the output stream. Why?
17. My MDIO device in not listed. What do I do?
18. Can I have multiple devices with different addresses share with the MDIO interface? Can I open several application windows and access different devices through MDIO at the same time?
19. Can the preamble length be changed?
20. What is the lowest voltage that the USB-MPC will work with?
21. What is the MDIO pin out for the 10-pin connector on the front of the USB-MPC?