FDI is committed to providing the best support possible for it's products.  If there is an answer that you cannot find or if you have additional questions, you can send an email to .  We will respond directly to your inquiry as quickly as possible.

General Questions:

  1. Can the XTEND be operated in 8-bit mode?
  2. Will the XTEND support different LCD's?
  3. What is the maximum clock speed the XTEND supports?
  4. Which serial port does Crossview Pro (XVW) use on the XTEND?
  5. Can I use an emulator with the XTEND?
  6. Can XMON and TASKING XVW coexist?
  7. Can XMON load the TASKING XVW debugger?
  8. Can I get a copy of the XTEND schematics?
  9. How much memory does MonXA support?
  10. How do the XMON monitor and the Tasking XVW monitor/debugger differ?
  11. Can the Raisonance MonXA and the Tasking XVW Monitor coexist?
  12. How much memory does XMON support?
  13. When running internal code, external memory fails.

XTEND-Gxx and XTEND-Sxx Questions:

  1. Can the XTEND be operated in 8-bit mode?
  2. How can I use an 8-bit peripheral with the XTEND?
  3. What version of software is the HiTech C Compiler and the CMX RTX RTOS that is included with the XTEND-G3 and XTEND-S3 kits?
  4. The software for the XTEND-S3 will not complete the installation.
  5. How can I utilize the I2C connector on the XTEND-G3?

XTEND-H4 and XTEND-SCC Questions:

  1. How do I upgrade my XTEND-H4 to use a DRAM module instead of SRAM?
  2. How do I upgrade my XTEND-SCC to use SRAM instead of a DRAM module?

XTEND-C3 Questions:

  1. I'm currently developing a CAN application and want to use the XTEND-C3. What will the XTEND-C3 communicate with if I don't already have any existing CAN hardware or an existing CAN network application?

General XTEND Questions:

  1. For the XA-H3, XA-H4 and XA-SCC, is the state of Bank 0 the same after all 3 types of Reset?
  2. How is the Bank 0 bus width affected by the three different types of resets?
  3. Which type of 4Mx16 DRAM does the XA-H4 support and what setup values are needed?
  4. If the system stack for an H4 is not located in the first page of memory, where do I locate the stack?
  5. Does the XA-H4 DRAM controller support SDRAM?
  6. What speed memory devices are needed to run code on the XA-H4 with no wait states?
[an error occurred while processing this directive]