USB In-Circuit Programmer for 80C51ISP – USB-ICP-80C51ISP

USB-ICP supports In-System Programming or ISP mode on NXP 80C51 based microcontroller families. In-System Programming uses a two-wire serial interface to program and erase ISP enabled microcontroller devices without removing them from the system.

Part #: USB-ICP-80C51ISP

Status: END OF LIFE

  • Supports NXP P89C51 family of microcontrollers
  • USB port power so no external power supply required
  • Free NXP Flash Magic software available from NXP
  • Target Device Voltage range of 3.0 - 5.0V
  • Mini-ISP Cable provided

>> See the brochure
Overview
Overview

USB-ICP supports In-System Programming or ISP mode on NXP 80C51 based microcontroller families. In-System Programming uses a two-wire serial interface to program and erase ISP enabled microcontroller devices without removing them from the system. The ISP function uses only six pins: VCC, GND, RXD, TXD, PSEN- and RESET. A small connector is all that is needed to interface your application to the USB-ICP programmer.

USB-ICP-80C51ISP Kit Contents
  • USB-ICP Dongle
  • 18″ cable allowing direct connection to the user’s application
  • ICP design guide for the user’s target board

Specifications
Specifications
  • Supports NXP P89C51 family of microcontrollers
  • USB port power so no external power supply required
  • Supports USB 1.1 to 2.0
  • Plugs directly into any standard USB Port – great for laptops
  • Works with NXP free Flash Magic software that can be downloaded from the web
  • USB-ICP supports Target Device Voltage range of 3.0 – 5.0 V only
Documentation
Current Documentation

Download all current documentation (zip)

TitleTypeFormatDate 
BrochureBrochurepdf02/02/2013
Quick Start GuideQuick Start Guidepdf
Supported Device ListDocumentpdf09/06/2013
Cable Pinouts and Target Connector InformationDocumentpdf
Flash Magic Release NotesDocumenttxt
Windows 2000 Installation InstructionsDocumentpdf
Software
Software

TitleTypeFormatDate 
Software Tool to Identify USB-IPC Firmware VersionSoftwareexe
Windows 7 DriversDriverszip
USB-IPC v1.07 UpgradeSoftwarezip06/13/2008
Windows XP DriversDriverszip06/11/2004
Windows 2000Driverszip06/11/2004


Flash Magic 

Flash Magic is a PC tool for programming flash based microcontrollers from NXP using a serial or Ethernet protocol while in the target hardware.

Click here for Windows 7 drivers (Externally-hosted)
Up-to-date Windows 7 VCP drivers