• Skip to primary navigation
  • Skip to main content
FDI: Future Designs, Inc.

FDI

Future Designs, Inc.

  • Products
    • μEZ GUI
    • ELI
    • ΣyG
    • Modular Development Kits – DK
    • Other Products
    • End of Life
    • All Products (By part number)
  • Engineering Design
  • Production
  • Support
    • Forums
  • About FDI
    • News
    • Management
    • Partners
    • Distributors
    • Practices
    • Careers
    • New Customer Referral
  • Contact Us
  • Show Search
Hide Search

Reply To: not able to find out of box(OOB) demo image

Homepage › Forums › μEZ › µEZGUI-1788-70WVM › not able to find out of box(OOB) demo image › Reply To: not able to find out of box(OOB) demo image

February 6, 2025 at 10:54 pm #16864
Logan Moon
Keymaster

    Sandeep,

    Please see the software tab here on the product page for the SD card files.
    https://www.teamfdi.com/product-details/uezgui-1788-70wvt#software

    For the touch screen issue please confirm the following:
    uEZGUI Rev number (printed on backside of unit in silkscreen)

    uEZ version used

    Did you compile the uEZ/Build/Generic/NXP/LPC1788/FreeRTOS/CrossWorks library in debug mode with no changes to the code?

    Did you compile the uEZDemos/Build/FDI/uEZGUI/uEZGUI-1788-70WVT/CrossWorks demo project in debug mode with no changes to the code?

    Do you see any visible cut or puncture in the touchscreen tail? They are fragile so please be careful.

    Is the touchscreen \”tail\” fully seated in the 4-pin connector?

    When you boot up the newly compiled software, please hold your finger down on the touchscreen, them attempt to complete the calibration procedure when it appears on the screen.

    Bill

    Partners

    NXP
    Renesas

    ARM
    SEGGER

    STMicroelectronics
    SAFERTOS

    FreeRTOS

    Copyright © 2025 Future Designs, Inc. | μEZ GUI | ELI | Engineering Design | Production | Privacy Policy | Log in