not able to find out of box(OOB) demo image

[Logan Moon]

Hi All,

I have purchased UEZ GUI 1788-70 WVM development kit. To hands-on programming and flashing, I flashed uez gui demo app on board using Rowley crossworks and segger jlink lite jtag . uez GUI demo screen appears on LCD with icons. But I am not select any icons. for example I am not able to select slideshow/Apps icon available on screen.

Now I would like to go back to Out of box demo software application. But I am not able to find Out of box demo image anywhere in SD card. Could you please tell me where can I find out of box image file and steps to flash ?

Thanks in advance,
Sandeep

[Logan Moon]

Sandeep,

Please see the software tab here on the product page for the SD card files.
https://www.teamfdi.com/product-details/uezgui-1788-70wvt#software

For the touch screen issue please confirm the following:
uEZGUI Rev number (printed on backside of unit in silkscreen)

uEZ version used

Did you compile the uEZ/Build/Generic/NXP/LPC1788/FreeRTOS/CrossWorks library in debug mode with no changes to the code?

Did you compile the uEZDemos/Build/FDI/uEZGUI/uEZGUI-1788-70WVT/CrossWorks demo project in debug mode with no changes to the code?

Do you see any visible cut or puncture in the touchscreen tail? They are fragile so please be careful.

Is the touchscreen \”tail\” fully seated in the 4-pin connector?

When you boot up the newly compiled software, please hold your finger down on the touchscreen, them attempt to complete the calibration procedure when it appears on the screen.

Bill

[Author]

Posts