- This topic has 0 replies, 1 voice, and was last updated 1 month, 2 weeks ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
(This message was transferred over from our old forum)
Posted August 14, 2015
By Todd DeBoer
[hr]
On 10/9/07 Rtheta asked, “Should the program execute when programming is finished?
FM doesn’t generate much feedback and the BLINK program seems to load but I get no flashing LED. When I probe the derivative board I can’t see power on VDD.
The USB dongle LED flashes when programming is under way so I assume something is happening.”
[hr]
(Follow up post)Answered:
See USB-Dongle Users Manual, page 18, for instructions on how to run programs after programming.
Also – don’t forget to set the device options – also detailed in the Users Manual.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.